Tell us about yourself!
Tools + Materials for 3D Printing
3D Printing Class
Balloon Powered Single Cylinder Air Engine Toy Train
Did this today and when I finished the wax wasn't very even. I threw them in the oven on 225 for about 10-15 minutes, folding them in different ways to keep even heat. When they were "done" I pulled them out with a pair of tongs and let them cool. In the end the wax looks very even and I'm pleased. As a side note, if you do this, there will be a light linseed oil smoke smell but 225 is too low of a temp to cause any real issue. Thanks for the post Nathan!