3 Simple Ways to Share What You Make
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Create on the go:
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Jun 12, 2009
96,168
%50%
%0%
Visit Our Store »
Go Pro Today »
Comment: Hi Jeff I pretty much laid it out as in the eagle schematic.I then bent the power and…
Comment: mix the catalyst at 1% to slow the curing and stop excessive heat.
Comment: 1/2 watt would be better you should be able to find those or 1/4 1/8 will work but bo…
Comment: Hi Janwil , i love the idea of storing a .gif and counting the requests for it .Its a …
Comment: To elevate the circuit within the casting I soldered a couple of wire risers on the vir…
Comment: yes that will be fine Kivanovi
Comment: Thanks Anywhere from 1k to 10k will be good it all depends on the input voltage and h…
Comment: no sorry its a one off
Comment: Actually 1/8 was my mistake which I pasted a few times it should have read 0.6 watt me…
Comment: Recuat, I just updated the instructable to include the exact type I used. "Polycraft…
Comment: Its actually a polyester resin I believe. Polycraft DSM Synolite Water Clear Casting …
Comment: I didn't use a vacuum dome, apparently this resin has good air rejection
Comment: I do know that this particular resin weighs around the same as water.But if it was poss…
Comment: I had considered the capacitor issue, I think the best workaround would be to drill a s…
Comment: I don't see a reason that the polarity could be reversed if your using a manufactured p…
Comment: I had some concerns while building the amp it was starting to look like a TV Aerial bu…
Comment: In this Circuit the current draw is less than 20ma so heat is not an issue .If you chos…
Comment: I simply cut the PVC jackets off the capacitors, just for appearance sake. One thing …
Comment: Thanks :) If you look at the bottom of the instructable I tested for heat issues.It ga…
Comment: Thanks and yes I loved the bare skeleton look also :) But it was too nice to hide and…
Comment: Hi Thanks for all the great feedback. Its the first time I have cast anything so my ex…
Comment: Nice Job !Heres another DIY brake thats good for thin sheethttp://runawaybrainz.blogspo…
Comment: I already tried Eagle Astro :) it is Expresspcb http://www.expresspcb.com/ExpressPCBHt…
Comment: Hey RandofoWhat PCB Design program do i use to open the source file "8pinshielf.pcb" ?T…