Tell us about yourself!
Does that work with trees, like walnuts?
3D Home Printer With Arduino
EWaste 60$ 3DPrinter
You could, but you would need arround 10 - 15 in parrallel. or you could use 30 of these https://www.aliexpress.com/item/High-quality-5-pcs-lot-25V-10000UF-18X35mm-10000UF-25V-Electrolytic-capacitance-ic/32830343644.html?spm=2114.search0104.8.88.PgTUE0
I was actually thinkimg of motorless aproach where draft would be created by difference in air pressure and temperature of the air.
Is there a difference which way the blower is blowing? I asume either way should be ok as you just need to introduce oxygen. I was just thinking, if hooking this to a tall pipe to work as a chimney, it then should work in passive way.
Welcome to CNC
Neat! This one should be great to work with steel indoor, I think, however, an improvement may be done for heat treating knives to make, a horizontal crucible imbeded in to the forge, so that you do not touch the heating element with knives. Other than that - what is the power of this forge (how much electricity does it consume?)
What kind of glue are you using?