Tell us about yourself!
I'm getting this error: Failed to open serial port COM4 to communicate with board Uno. Make sure there is no other MATLAB arduino object for thisboard. For troubleshooting, see Arduino Hardware Troubleshooting.But then I have updated the drivers for the ports,installed all arduino-matlab packages etc..I have connected only arduino to COM4.I'm using Matlab 2016a. Kindly help.
Which servo motors are you using? I am trying to make it using Tower Pro MG995 servo motors,but not getting how to connect the two.Kindly help.
How did you connect the 2 servo motors and the camera?Could you please explain the hardware set-up?