Tell us about yourself!
Just had an inspection done and there was no mention of this having to be redone. The inspector did recommend adding a vertical support, but the actual work noted in the instructable was counted as good and passed inspection.
Thanks for the terminology update - I'll make the change.
Probably a lot cooler under there ;)
Fix It: Attic Rafter Scab -...View Instructable »
TS1 modular shelving (with CNC wood threading)
3D painting: Layered Resin and Acrylic Paint
Raspberry Pi: Wall Mounted Calendar and Notification Center
I just had another idea - use the table saw to add a groove along the edge for the twine to run in on the outside of the mat. It might give it a cleaner look. Also, a nylon colored cord (black or brown) might hold up better.
This is great looking and involves some basic woodworking skills. I think there are some techniques that have been mentioned that been mentioned that might reduce the labor involved. One idea I had was to make your back rail for the drill press taller and the flat edge of the block would be a way to keep it aligned properly. That way, you could route the longer strips before cutting and drilling.At any rate, great project and am definitely going to try this one - perhaps with palette wood - just to get the "reclaimed" or "up-cycled" vibe going.
How to Make Arduino Based Mini CNC Plotter Using DVD Drive
LEDs and Lighting Class
Thanks - my version only weighs a few pounds and can easily slide under a bed when collapsed. Easy to travel too if you need a quick stool or low stand.
Collapsable Low TableView Instructable »
Inexpensive garage lights from LED strips