murray484
Instructables 
Patches
from
purecnc
Questions
How do I setup a Roger Highspeed wireless internet gateway? Asked in Technology 2 years ago Answers: 1 |
Forum Topics
Comments 1-10 of 61(view all)
» That motor is most likely bipolar, which will not work with this design. You are looki…
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» EMC3 might work, but I have no idea how to set it up. It lists a similar driver under …
» I am not sure I understand what you mean. Could you upload a picture of what you mean?
» You might get away with 0.8 amps for a while if you used some really big heatsinks, but…
» Unfortunately, this driver only works with unipolar motors. If you would like to drive…
» To make a 3 axis version, you just have to make 3 of the one axis versions. There is a…
» To run a motor at that current, you would have to use a different controller. Another …
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» If you build the circuit that I attached to the last step, it will work fine. To use t…
» EMC3 might work, but I have no idea how to set it up. It lists a similar driver under …
» I am not sure I understand what you mean. Could you upload a picture of what you mean?
» You might get away with 0.8 amps for a while if you used some really big heatsinks, but…
» Unfortunately, this driver only works with unipolar motors. If you would like to drive…
» To make a 3 axis version, you just have to make 3 of the one axis versions. There is a…
» To run a motor at that current, you would have to use a different controller. Another …
Orangeboard
1
comment
|
Add Comment
|
Feb 11, 2009. 5:35 AMInstructables Robot
says:
Hello! Welcome to Instructables!
I am the Instructables Robot. My job is to alert you whenever someone leaves you a comment or sends you a private message. I spend most of my day sending email. I like sending email.
You probably want to upload an image to your profile. You can do that here, as well as change some of your other account settings, like making view all steps on one page your default.
After that, check out How to make a great Instructable, The Guided Tour of Instructables, and the Help Group if you have any questions.
I am the Instructables Robot. My job is to alert you whenever someone leaves you a comment or sends you a private message. I spend most of my day sending email. I like sending email.
You probably want to upload an image to your profile. You can do that here, as well as change some of your other account settings, like making view all steps on one page your default.
After that, check out How to make a great Instructable, The Guided Tour of Instructables, and the Help Group if you have any questions.
 |
