loading
2Comments

Tell us about yourself!

Complete Your Profile
  • Da Vinci XYZ 3D Printer Filament Counter Resetter

    I had this same error with version 1.6.6 of the Arduino IDE. Try downgrading to version 1.5.8 or lower. After doing so it compiled for me with no problem. When using this ensure your correct COM port is selected and turn on the Serial monitor (under tools-serial monitor or by pressing Ctrl-Shift-M) with a baud rate of 115200 so you can see the program's messages. Look for a success message after it writes the new EPROM contents.

    View Instructable »
  • netnap commented on scottrevoman333's instructable Da Vinci 1.0 Filament Reset12 months ago
    Da Vinci 1.0 Filament Reset

    I had this same error with version 1.6.6 of the Arduino IDE. Try downgrading to version 1.5.8 or lower. After doing so it compiled for me with no problem. When using this ensure your correct COM port is selected and turn on the Serial monitor (under tools-serial monitor or by pressing Ctrl-Shift-M) with a baud rate of 115200 so you can see the program's messages. Look for a success message after it writes the new EPROM contents.(I haven't validated it but I think the new Arduino version may have deprecated the boolean data type for bool. I saw a reference to a recommendation to use bool instead of boolean. This would be why downgrading give you a different result.)

    View Instructable »