With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
LEDs and Lighting Class
Make a 3.3 V & 5v Power Supply @ 1.5 Amp.
Getting Started with Electronics
No, unfortunately there is nothing you can do to make the I/O pins on the UNO to 3.3V. By design the pins are 5V.And again, powering something at 5V if it is designed for 3.3V is a very bad idea....So you either use a couple of resistors (if you don't care about efficiency) or use a DC-DC converter. That is the best way.
WannaDuino,well don't get confused with the power input of the Arduino Uno (R3) which is 3.3V and the output pins (GPIO) which are 5V.You can power the ATmega328 with 3.3V but you cannot output 3.3V on the GPIO pins. This is valid 100% for the original Arduino Uno R3.However, there are Arduino clones with 3.3V GPIO out there, you might have one of them.Hope this help!Regards,Paolo
Take apart a Compact Fluorescent Bulb
Thanks for the instructable.Do you have a list of materials and cost?Thanks!
Breadboard Friendly Tactile Switches
The Arduino Mothbot
PiStation - A Raspberry Pi Emulation Console
DIY "PRO" DSLR slider for $10
Capturing the Milky Way
Electronics Basics : Diode
Simple & Cheap Arduino Uno ATmega328 Programmer
Not the best idea to connect the I/O pins directly to 5V.It might work, bu you might significantly shorten the life of the components.The BT chip is *NOT* 5V tolerant:https://cdn.sparkfun.com/datasheets/Wireless/Bluet...
Twinkling Branches Room Divider
Supercade - How to Design and Build a Bar Top MAME Arcade
HomeMade Modern DIY Concrete: Coloring & Casting
Custom Kitchen Island with LED lighting
How to Make a Match Rocket
Apple Rose Tarts
Image Transfer to Wood
The single most effective way to get rid of a sunburn
Turn a broken laptop screen into a portable light table for drawing
Hutch Re-purposed to a BAR DIY
Solar Scare Mosquito
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.