loading
4 CommentsUSA

Tell us about yourself!

Complete Your Profile
  • pctech334 commented on punkkills's instructable Micro 105 FPV Quadcopter - 3D Printed5 months ago
    Micro 105 FPV Quadcopter - 3D Printed

    Dump is here:https://goo.gl/oC239S

    Were you able to bind the radio successfully?Yes, Receiver tab shows the sticks responding to movement on QUAD. What is min_command set to? It should be 1000.Yes, set to 1000.What batteries are you using? Is it possible that you hooked up the battery with reverse polarity at some point?Using the battery that from parts list on Thingiverse. N possible polarity switch as the connectors do not allow for the incorrect connection. Go to the CLI and type "dump". Can you copy and paste the output to a text file that you can share somewhere, like dropbox or google drive? Can do with Google Drive. Please DM me your email so that I can give you sharing ability.

    I checked and the motor_pwm_rate is = 32000. However, still no change.

    View Instructable »
  • pctech334 followed punkkills5 months ago
  • pctech334 commented on punkkills's instructable Micro 105 FPV Quadcopter - 3D Printed5 months ago
    Micro 105 FPV Quadcopter - 3D Printed

    I built the quad copter, bound it to my receiver (Spektrum DX6i). Followed the clean flight config and set it all up. All channels show correct and respond in CF correctly as far as I can tell. FC shows it is connected. However, when I connect the battery to the quad, motors 4 & 3 become active immediately. They spin no matter if the receiver is armed, disarmed or even on. Motors 1 & 2 are unresponsive. Tried to do a motort spin up in CF and no responses from nay motor. I thought I had too much solder connecting the pads so I resoldered them on motors 3 & 4. Motors 1 & 2 had cleaner solder points. Still the same effect. Not sure what I am doing wrong or how to trouble shoot this.

    View Instructable »