With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
That 1.5ohm resistor you depict is more 0.75-0.8 ohms.
This instructable is nonsense. Installing this into your car and modifying the O2 signal will at least just waste MORE gasoline, worst case cause irreversible engine damage like melted pistons, burnt valves, possibly blown head gaskets or spun bearings. YOU HAVE BEEN WARNED!
HHO = H2O.. Just get a better car! There is NO tangible evidence of this working, EVER.
huh?! Modern Alternators have 90A+ capability, PWM based regulators and a steady regulated output voltage of 13.8V. A correctly functioning alternator will have 0A output at 0A load. You should upgrade/replace your alternator if it operates as you describe. Also if this system causes the ENGINE to run lean then you run int detonation, worst case = spun rod bearings or melted pistons.
should not buy parts from ebay, use digikey or better, Mouser dot com.
DIY high resolution 3D DLP printer (3D SLA printer)
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.