Tell us about yourself!
For me the issue came from the merge, PSKEY_BDADDR was not merge properly. I set it manually and it works well. Check the 3 values after merge part
When I had the merge issue, the module was not visible. When merge is ok, the module is visible for me.
hello,I did it with an FTDI as SPI programmer, I was able to dump the files and the setings of the HC-05, I flashed the files of the RN42 given in message below, I did the merge. Everithing seems to have be done correctly, Bu when I try to use it, nothing appends :(do the output pins of the breakout board are still right ? specially RX TX ? how can I test the RN42 functions ? I tryed sending $$$ but got no responses what is the baud defautl value ? I tryed 115200 and 9600 but nothing worksthanks
$3 Bluetooth HID Module (HC05 With RN42 Firmware)
The gerber files were added in the InstructableRegards
I have some at home, I build 30, i can sell some of them if you need
Nice work !!!I realy enjoy doing it, and use it every day at home nowthanks for sharingregards PH
No problems to share, Where can I put gerber files ?Give me your address
ESP8266 Weather Widget