loading
9Instructables169,658Views68CommentsJoined September 23rd, 2007
Mops from sticks and rags. Cheap!

Achievements

10K+ Views Earned a bronze medal
  • stickmop made the instructable Cheap, Easy, Low-waste Bookshelf Plans4 weeks ago
    Cheap, Easy, Low-waste Bookshelf Plans

    I've made three of your platform beds now and this past week I made a variation of these bookshelves (my third set of these). I wanted some 1x8 shelves to fit along one section of my garage in my latest house and I wanted them flush with the wall. So...I cut the threaded rod around 12" long, found the studs and drilled 7/32nd" holes a couple of inches into the studs at the height I wanted for 7 shelves. Then I "screwed" the threaded rod into the studs with my drill. They snugged up nice and tight in the holes. Once that was done, I held each 1x4 support up to the row of rods and tapped them with a mallet to mark where the holes should go, knowing that my stud drilling didn't follow my plumb line. Then I drilled holes for the 2 or 3 longest rods, and repeated the tapp...see more »I've made three of your platform beds now and this past week I made a variation of these bookshelves (my third set of these). I wanted some 1x8 shelves to fit along one section of my garage in my latest house and I wanted them flush with the wall. So...I cut the threaded rod around 12" long, found the studs and drilled 7/32nd" holes a couple of inches into the studs at the height I wanted for 7 shelves. Then I "screwed" the threaded rod into the studs with my drill. They snugged up nice and tight in the holes. Once that was done, I held each 1x4 support up to the row of rods and tapped them with a mallet to mark where the holes should go, knowing that my stud drilling didn't follow my plumb line. Then I drilled holes for the 2 or 3 longest rods, and repeated the tapping process, trying to keep each rod pretty level. Once the supports were up, I snapped the shelves in (toward the supports) and tightened the nuts. Instead of using cap nuts, I used regular nuts and cut them mostly flush with my saws-all. Looks and works good!

    View Instructable »
  • stickmop's instructable Curtain Cleats --- Cord Management 101's weekly stats: 3 months ago
    • Curtain Cleats --- Cord Management 101
      15 views
      0 favorites
      0 comments
  • stickmop commented on jaoami's instructable SUP From Whitewater Canoe3 months ago
    SUP From Whitewater Canoe

    I was going to guess a Blue Hole OCA - mine was almost that thrashed when I sold it. Those old flat bottom whitewater ABS canoes were the original SUPs to my way of thinking - I even ran a few Class III drops in mine standing up. They did oil can/flex a bit. Cool repurposing!

    View Instructable »
  • stickmop commented on mirandmanga's instructable Stackable Pencil Trays 1 year ago