Tell us about yourself!
With all my power tools, with fences and guages, I could not make that look so good.
I was going to write this also. I was just looking to see if it had been said already.
When sanding, I would put a piece of wood rather than have the metal table exposed. I drill a hole in this wood the size of the drum and have the drum go into the hole a wee bit. This will make it so when I put my project against the drum, all the work is sanded the same, rather than having a bur at the bottom edge. (I hope this is clear)
You can fix anything with duct tape, except duct tape.For that you need zappy straps.
What is PU Spray and Liquid?
I think it would be easier and cheaper to get the yeast and forget about making holes in your house.
Tools + Materials
Meet Your Saw
Table Saw Class
Here is my open concept. It disassembles and goes flat (five layers of plywood high), all round access. I didn't put doors between rooms though.I think I will build one like yours, too.
You night not like using a wood lathe then. There is usually more shavings on the floor than wood in the final product. Actually, with me, there are usually more broke, messed up, or ugly pieces in the fire box than finished products going into the house.
We have an outside sink with a garburator in the bottom of it, like is in lots of kitchens. There is just a short pipe for the discharge and we have a bucket under it.We put our compost stuff in the sink, turn on the water and flip the switch. When the bucket is near full we stop motor and stop water. either get another bucket or take and dump this one on the garden or on shrubs or fruit trees.
What do you mean?
To get black shoe marks off the floor, put on your running shoes, and wipe the mark with the sole of the shoe, when it is gone, step over to the next one and remove it.I do this walking down the halls at school all the time.