Tell us about yourself!
Hey, did you print your 3d parts in ABS or in PLA?
well I'm assuming those pins are not being used right? So why would I not omit them if I'm not using them. I'm still confused about the [1,2] pins at the powerjack, are also these not being used?
is the [1 2] rectangle at the power jack/in_ground also can be omitted?
allright, and same goes for the 2pin-connector connected at POWER_JACK and IN_GROUND? (also shown in the same picture)
Hello I have a question, is the a6 + a7 a direct connection to the powerjack and ground. I'm asking this question because there is a box with the 1 and 2 inside of it. (see added image)
So they are both seperate 2 pins connectors? Why did you connect those, cause I assume you're not using them?