Tell us about yourself!
GWL11 US Product code 96151-B.The pump went out a couple of day ago and took out the control board. About four years ago I bought a donor machine from Craigslist for 20 bucks... it had bad bearings, But everything else was fine. I transferred the control board and the pump over to my machine. I want to add a inline fuse to the pump to prevent this from happening again. Other than the ground wire I have a brown and white wire that goes to the pump. What wire do I add the fuse to?Thanks
I think the best and cheapest idea would be to get a slide in camper for a pick-up truck used off of Craigslist. For about 3000.00 you can get a nice one, fully equipped....even with a shower. You can park it at the camp ground and run around with the pickup. Your going to spend allot of money refurbishing that exambulance for camping.
Cool project..you could soak some wax into the cardboard to make it waterproof. Thanks for sharing
Cool project. Just like the control board they write on in the control room of a aircraft carrier. If you sand and then flame polish the edges of the Plexiglas you will get better light transmission.
Easiest Microwave (MOT) Salvage/Re-use Tutorial
Bring Dead Ni-Cad Batteries Back To Life