loading
4Comments

Tell us about yourself!

Complete Your Profile
  • wes13y commented on SLOMakerSpace's instructable Laser Cut a 3D object using 123D Make4 months ago
    Laser Cut a 3D object using 123D Make

    to change the thickness of the material, use a decimal (,) not a point (.)

    to change the thickness of the material, use a decimal (,) not a point (.)

    to change the thickness of the material, use a decimal (,) not a point (.)

    I can't change the thickness of my material in increments less than 1mm at a time, which is frustrating when the only card I can buy comes in 0.6, 1.2, 1.8, 2.3mm.. any suggestions?

    View Instructable »