With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
How to Build a Shed
DIY Reupholster Vehicle Door Panels
The two top screws are under the sticky label. You can either remove it (I did) or just cut holes to access the screw heads. Use finger pressure to locate the indentations.
Hi there-- I have one of these and am trying to follow your instructions. I see two screws at the bottom of the control unit where the cord comes in. I've unscrewed those two but CANNOT seem to get the control unit open. Where are the other two screws? Thanks!
All I did was separate the battery from it's hosting using a small screw driver. Reset the unit just fine. Now it may expire in 270 but it will be sold long before that.
Thanks for the advice. Now I took mine apart and just separated the battery for a second and now system is working fine.
So if we disconnect this battery and it can't track the time, but can still count number of times used, it sounds like there may still be a problem using the unit beyond X uses. This suggests it has NVRAM somewhere that is holding this figure.
We may have different units. However, I opened mine and attached a couple of photos here, where you can see the battery connector; as well, the CMOS/disc battery to the left. From your description, it's not clear this applies here. Could you comment? Thanks!
Just seeing this now. Thank you for replying, I will take a screwdriver to this and see if I can find this. Will post after.
Curious if this is the same brand I posted above. Would you be able to post a photo?
I have one of these that I wish to re-activate.First, why do they de-activate after X treatments? That's because the providers felt they were getting ripped off by these devices being re-sold on eBay, etc.From my perspective, my insurance paid on my behalf about 4k for this, so I do NOT accept that it's deactivated.When bone is growing, it emits a specific magnetic signal. These units work by imitating that signal.I included an image of the internal/battery/port side of the control unit. This is made by DONJOY called a "CMF". That port above the 9v battery looks clearly like a computer connection (maybe serial). I don't dare take it apart yet. But I wonder if someone here might know how to access this unit and remove the restriction/disable/block.
it quits after 9 months...mine cost $3500.00 USDbehind the battery is a ten pin receptacle...find a brainiack....me no clue
Table Saw Projects
How to Setup and Run a Hydroponics System
Google Play Music Internet Radio (Raspberry Pi and Arduino)
Candle Powered Pottery Heater
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.