I don't have a 3D printer and was thinking of using Shapeways to print your parts. On upload of the STL files they need to know if the measurements are in mm's or inches. Please let me know? Also have you made your files available on OSH Park? I thought PCB designs could be shared on there to make l...
Hi Brett, today finally I could turn on the circuit and try it. The 4 matrix screen does not work properly. When I touch one of the sensors I notice that it changes its mode.. clock letters, analog clock, temperature, but without the LEDs being well marked. When I press RESET on the arduino board, t...
I am new to stepper motors and didn't have one. Just need to make sure that I will buy the correct stepper. My project is about DSLR camera pan + tilt and for slider, so it will be 3 steppers. Maybe can carry 1.5kg - 2kgI already have the following:Battery: Laptop powerbank USB1:5V/2.1A USB2: QC2.0 port 5V/2A 9V/2A 12V/ 2ADriver: Adafruit Motor Shield V2 for ArduinoArduino: DFRduino UNO R3And some 1:40 reduction gears from past projectAbout the stepper I'm planning to order in Bangood.com and here is my choices: 12-24v, 1.8 step, 0.5 amps, 20 resistance, 1000g.cm hold, 80g.cm detent 12-24v, 1.8 step, 0.28 amps, 26 resistance, 700g.cm hold, 60g.cm detent 12v , 1.8 step, 0.4 amps, 30 resistance, 28n.cm hold, 1.6n.cm detent 12v, 1.8 step, 0.4 amps, 30 resistance, 260mN.m hold, 12mN.m detentPlease let me know what should be best for my project. I'm not expert in steppers. If you have any suggestions that would be great.Thank you!
Posted by coreuploader 12 hours ago
My entire instrument pannel is flat lined, no lights, not even a ding for low gas. Will this solution work for me. 2003 GMC Yukon. Thanks!
Asked by SandraL119 on DIY: Finally! How to Repair a GM Instrument Cluster at Home - Speedometer and All Gauges. for Silverado, Tahoe, Yukon, Suburban, Sierra, H2, Avalanche and Other 2003, 2004, 2005 and 2006 Chevrolet GM Vehicles. 14 hours ago