How do I make a motion/touch-activated sound player?

Hey everyone,I'm looking at making a device that plays a single .mp3 file when it is moved/interacted with, i.e the device will be in a container of sorts, and when that container is hit or shaken, the sound file will play. Is this possible?I've tried looking on the website for similar projects but couldn't find anything as all the motion-sensor ones were to do with if something walks or moves in front of the device, whereas I want something where the motion is acted upon the device.Hope you can help me out!Thanks

Asked by s3542476 9 hours ago

Fairground ride Light setup

Hiya Everyone, I was wondering if i could have some help, I have recently purchased an old fairground ride light using cabochons and incandescent bulbs 240v @ 10W each and have wired it up in a 3 phase series circuit. Now the light works fine as a light however me being me id like to allow for each part of each letter to be controlled individually so i have split the signs into three areas purple, green and yellow and i would like to program something to control each part individually and allow for it to either flash or dim each part moving onto another transition, ive had a look around youtube and google but cant really find anything else like this. Please see attached photo of one of the letters

Asked by JamesT402 9 hours ago

How to delete my own post.

I accidentally double-posted in the comments section of an instructable. I'd like to delete one of them. How do I do that?

Asked by fkeel 13 hours ago

Are we losing you guys? LOL The organization seems a little out of balance these days. :)

Are we losing you guys? LOL The organization seems a little out of balance these days. :)

Asked by Attmos 14 hours ago

HM-11 Bluetooth module: How to change the baud rate

I'm writing some code to use an HM-11 Bluetooth moduleAfter switching on it responds to AT, AT+BAUD? etc. commands - the default baud rate is 9600, 8N1I now want to change the baud rate to 38400. The procedure is:1. Send command "AT+BAUD2" at 9600 baud2. After the last command character has been sent change the baud rate of the receiver (SAMD21J) to 384003. Wait for the response, which should be "OK+Set:2"The response never comesWhat am I doung wrong?Thanks for any hints,Jerry

Asked by JeremyR85 15 hours ago

Are there any ammonium sensor for salt water with I2C interface?

Hi, I am a newbie to anything electronic.I am trying to design an array of sensors for a salt water aquarium. I have found the DO and pH sensors from Atlas, now I need a temperature and ammonium sensor for the salt water tank, all with I2C interface.Does anyone out there know of any they can recommend?

Asked by achaninau 15 hours ago

Please help me / arduino

I know this is a stupid request, but can someone please code for me the movements of the robot? I will attach a video on how I want it to move. I will only use motors sg90, jumpers, and arduino but I need the arduino code.So I want 4 things to move, you can see all of them in the video. I will then connect it to my computer and use my keyboard for movements. You are free to put any keys you want to control it. Please help asap. This project is for tomorrow for my school. That's why I don't have the time to learn arduino myself right now, if someone could PLEASE help me

Posted by Lexard 15 hours ago

Adding to Collections

Just wanted to post some feedback. After being away from Instructables for a while, I was trying to figure out how to add an 'ible to my collection, and had to google the answer. I hadn't even noticed the dot menu until that point, even after scrolling up and down the page and refreshing a few times. This process could be made more transparent.

Posted by KennethM4 17 hours ago