If you could, please upload the actual template file and not just an image. I really like this amiibo key chain idea, but I am absolutely horrible at making actual designs myself. However, with a proper template file, which I presume you have used to make these, I'd be able to switch out the images ...
My "Discussions" tab showed no changes for about two months, and then yesterday it dumped about two months of replies that people had made on my various comments I made on the forums here. I think that qualifies as a bug. I mean, ideally my "Discussions" tab would notifiy me of replies in a matter of hours, so I could reply to those replies in a timely fashion, if it was the sort of thing where someone was expecting a reply from me.I am guessing this problem was maybe related to the recent big "improvements" to the site, to make it more readable for mobile lusers, and other changes to make the site more comment-able, question-able, tip-able, by everyone.Just wondering: Has anyone else experienced this same problem, i.e. a several weeks, or months, delay in notifications of replies to your comments?
Posted by Jack A Lopez 8 hours ago
Hi, I tried to compensate the effect of humidity and temperature by measuring them with a DHT22. In principle I was successful, but then I did a trial with CO (a candle in a closed box). For my surprise the DHT22 is not only sensitive for humidity, but for CO, too. As the reaction time of the DHT22 ...
Bonjour MAXmy camera + cart + fluid viedo head weigth 2 kilograms . And I would like to lift this ensemble verticaly (70 cm) . Are these tutorial components strong enough? Thank youPS : picture of my aluminium profile and the new kart.
Asked by gruuz on Make an Arduino Controlled Motorized Camera Slider! 9 hours ago
I'm more asking for a direction to go rather than a specific problem. I've followed all the steps, tested with multiple media (wood, pressboard, acrylic), tested on multiple lasers with rotating settings - even on a CNC machine - and all I get is variations of pink noise. My needle stays in the gr...
Hey everyone,I'm trying to take an audio signal from an optical fibre cable pass it through a DAC0800LCN IC, 8BIT DAC chip and input into the Arduino. I'm trying to use a 3 pin fiber optica toslink transmitter to connect the fibre optical cable to the DAC chip. Does anyone know how to set this up or even if this would work? If anyone could answer this is would be much appreciated.
Asked by MCsugar43 9 hours ago