Hey guys,One of my project had made it to finalist on National Geographic, I would need your vote to make it further!Please spend a minute or two to cast your vote on NatGeo's website!https://www.natgeochasinggenius.com/video/3528Best,Peter
Posted by PeterM33 2 days ago
Hi, an HVAC person is telling me I don't need a relay for my Pellet stove, as the Nest just switches it on, and the millivolt thermostat is essentially doing the same thing, any thoughts? I would just need the 24V power supply.
Asked by SanjayP84 on Nest Thermostat With Gas Fireplace (or Other Millivolt System) 2 days ago
Hello, I'm new with this type of project. I have completely build the electronic circuit as here is posted but only with an arduino uno. There were no problems with the upload to the Arduino. With testing it went wrong, the buttons work barely but it can be my fault. the most annoying thing is that ...
So I am trying to help my grandparents fix there computer, they have a dell pc ( don’t know what exactly ) and a hp 22cwa monitor. The monitor will stay on in tell I plug the hdmi in then it says no signal then goes to sleep mode, I have tried new mouse and keyboard on the computer, as well as using another cord on this monitor and pc but neither work. I did take the monitor to my pc and used the same cords and it instantly worked with both cords just fine. Before today this monitor has been working for almost 6 months with no problem and now is randomly doing thos
Posted by alexberger1033 2 days ago
I would like to make a compact and simple circuit which either turns a small LED on or off at 0.7v. It's for a single AA electric toothbrush as a battery change indicator and would get power only when the brush is on. Because the motor slows gradually, I can't easily tell when it's time to change b...
Hi Amanda, what you have done is amazing (I havent found much newer info about that - so well done :)I have tried to replicate your idea using all you have provided. However - Processing reports an error. I'm using Modelbuilder v0007a03 (actually I have tried also Modelbuilder v0007a01, ModelBuilder...
I love this post! Way to find a resolution to a common problem. However, I noticed this post was really old. If anyone tried being crafty here and didn't quite do as well as they had hoped. These do exist (while definitely more expensive than this awesome hack).https://www.cpap.com/productpage/HoseB...
Tip by BrionneD on Make a CPAP (Continuous Positive Airway Pressure) Hose Holder for Sleep Apnea 2 days ago
Hi there I have 2 x 3m Bamboo split poles to secure to the top of wall as a border/replacement for coving.What would be the best way to secure to the wall? I cannot hammer into the wall due to a pipe running behind where the bamboo will go.Velcro? Silicone? Double-sided adhesive pads/strips?Don' want it falling down during a meeting LOL
Posted by GregoryD45 2 days ago
I have recently started hydro chrome but my problem of yellowing after the chrome, the sealant is not proper, I am using activator and no sensitized as u have mentioned, what is wetting agent, can I buy from open market, could u please let me know the chemicals needed for A, R solutions, sealant,...
Hi Bryan, ths project is really nice and inspirering ! I was actually designing a project with a 3D printed glove to remotely control several devices. Do you think I can take the image under "step one" for my project? My drawings look terrible :s
Asked by jeanotP1314 on Making 'Glove One' - a 3D-printed, Wearable Cell Phone. 2 days ago