Arduino D1 WeMos with LabView Answered
I want to build a project that gets information from the "Temp102" sensor connected to the D1 WeMos Board.
This board sends the information received from the sensor via WiFi.
I want this information that sends to the computer that has the LabView software and it will display the temperature in a termometer.
I have a program that I found in one of the sites that does what I want but with one problem!
The program is written for module Esp8266, which is connected to board Arduino Uno and therefore has different classics.
I need help converting the classics of module ESP8266 to relevant classes for Board D1 WeMos (This board has ESP8266 but it is built-in so there is no need to set it up in the program).
It's important to note that I tried to change it and make a "mix" but without success.
I would be happy if someone could check in the program what should be changed, which orders should be replaced?
(I believe it's 2 minutes work for anyone who knows)
Thank you very much for your help !
I appreciate you very much !!
I attached the programs (for arduino and for labview).