CD stepper motor controlled by PC? Answered
Is it possible to control a bi-polar stepper motor from a CD reader/writer with the original print board?
(so without adding any other IC's), and also with the original flat-cable?
I would like to create an XY positioning table with 2 of these stepper motors.
I don't understand much about data transfer trough a serial port, so I would like to keep using the original wiring (flat cable) that goes to the motherboard of my PC.
Does there also exist software to program a pattern (for drawing an image on the XY table) that sends signals directly to the stepper motor? (trough the flat-cable) ?
Thanks in advance,