206Views8Replies

Author Options:

I need to unsolder an shower connection which is located inside the wall without setting fire to the walls? Ideas? Answered

Tags:shower

8 Replies

user
Marcos (author)2009-04-24

What they said, + shove a piece of fairly heavy sheet steel (not aluminum) behind the area you're heating. If you have room a piece of sheetrock will do the trick.

Select as Best AnswerUndo Best Answer

user
lemonie (author)2009-02-13

Like Bardouv says, use a heat-shield, but consider a hot-air gun rather than naked flame?

L

Select as Best AnswerUndo Best Answer

user
gcrdcn (author)2009-02-11

Just cut the pipe and then use the quick connectors name Sharkbite to reconnect (if it is copper).

Select as Best AnswerUndo Best Answer

user
randomhat (author)2009-02-04

Yeah, you don't 'unsolder' pipes. Bathroom pipes are usually cut using a pipecutter. You still encounter the problem of resoldering your replacement solution into place though. And then you can usually get a sort of fireproof material, usually something that looks like a puffy foil insulation panel thing. But My father uses the fireshield from a propane camp stove, one of those folding 3 panel things.

Select as Best AnswerUndo Best Answer

user
mikeasaurus (author)2009-02-04

Pipe joints that are soldered together are usually not 'unsoldered', they just cut the pipe below the spot where they are soldered and attach a new pipe and solder it in place.

Your method has a very high probability of setting your house on fire, I do not recommend.

Select as Best AnswerUndo Best Answer

user
jeff-o (author)mikeasaurus2009-02-04

Agreed - the pipe is usually just cut. However, they do make heat pads for just this purpose, that hang or otherwise attach to a pipe to protect the wall behind. Look for them in the plumbing tools section at the hardware store.

Select as Best AnswerUndo Best Answer

user
Bardouv (author)2009-02-04

It might be a good idea to put aluminum foil or ceramic tile around the place your going to be heating up so that an open flame doesn't touch the walls. But as mike said, it is probably easier and safer just to cut it.

Select as Best AnswerUndo Best Answer

user
iPodGuy (author)2009-02-04

Try one of those butane lighters. They're a lot smaller than a torch.

Select as Best AnswerUndo Best Answer