3877Views3Replies

Author Options:

Printer Stepper Motor Driver Answered

I recently "Recycled" (parted out/junked) some Hewlett Packard 600 and 800 series printers. It occurred to me that everything I would try to build (electronic and software drivers) already exists in the printers. The motion of the stepper could easily be controlled by sending print commands to the "printer:. The only "problem" I can think of is satisfying all of the fault sensors, eg. out of paper etc. Has anyone worked on this. Recumbent Bike Builders Rule!! Carpe Ductum

3 Replies

user
NachoMahma (author)2007-08-08

. You can usually find Maintenance/Technical manuals online that will tell you where all the interlocks are located and how they are wired. Luckily, most are just mechanical switches that can be shorted/opened as needed. . Not familiar with the H-P 600/800, but if they are lasers, be VERY careful as high voltage is present and the fuser gets real hot.

Select as Best AnswerUndo Best Answer

user
naic98 (author)NachoMahma2007-08-09

They are both inkjets. I tried HP online, they said I shouldn't take the printers apart. I asked them if they had a schematic. I am not sure the service center person knows what a schematic is!

Select as Best AnswerUndo Best Answer