Prusa i3 newly build first 3d printer all together cant test print confused Answered
I recently just purchased my first 3d printer. I bought a Prusa i3 newest model here is the link -> http://www.ebay.com/itm/271714170595?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
It is this model
“LCD Screen Aurora Partilhada Model DIY Reprap Prusa I3 High Accuracy 3D printer”
I put everything together by watching the movie and looking at the wire diagram, I followed the movie and the wire setup. Everything is hooked up correctly. When I power on my 3d printer it turns on but when I try to do a test print it says it doesn’t say its preheating and only gets up to 21 degrees the bed and extruder I believe. But it is always at these temps it doesn’t start at 0 and work its way up.
So I am having issues getting the printer to run now.
I installed the filament as it showed but I cannot print anything to test and make sure it works.
What should I do?
I would love to print anything like a test piece just so I know my printer is working! Then I can continue to learn 3d Modeling and make anything that I can think of.