Vga cable gone wrong Answered
I've tried like 5-6 times to make myself a vga male-to-male cable for this 32" tv I have that I can't do anything but watch noise infested cable with.
So I'll skip all the bull****. I'm down to two cables I cut one from an old CRT and one from a non-working LCD monitor. Of course the lcd cable has to be considerably thinner, but the cables inside are relatively the same color.
I've used this , and this website for a little bit of reference, along with wikipedia's VGA Connector page. The only bit of useful information I really have is on the wiki page where it says the male connector is just a mirror image, but it still confuses me.
So far I have pins 1, 2, and 3 connected together at the cut end of the two cables, as they're the 3 thicker cables inside there. The rest of the cables seemed to be the same color as on the other cable, except that one had a black wire, and one with a red one (these turned out to be the same pin so I wired them together). The rest of the wires I matched together according to color and some of them I've heat shrinked, but I figured I better not waste any on wires I'm unsure about.
Sure enough, it does not work, my LCD continues to display no signal, and I'm now wishing I didn't cut apart the first hand made cable I had (I grabbed off a cart at school). But the image quality was crudd, and it turns out it was wired in the cable to 5 coaxial wires, probably causing the quality issue as it wasn't exactly standard.
Can someone tell me what the hell I did wrong???? Should it be wired differently instead of just a straight through cable?