4129Views4Replies

Author Options:

does anyone know how to connect this cirocomm gps module ? Answered

there is  a 8 pins connector with no indication at all  :-(

4 Replies

user
steveastroukBest Answer (author)2012-12-15

That's a Cerocomm PE-36 module.
http://rfetc.com.ne.kr/gps/DM-GPS.pdf

NOTE this is a 3.3V supply module - to use the serial interface you'll need a level converter, unless you use it to communicate directly with a processor ALSO running on 3.3v

Steve

Select as Best AnswerUndo Best Answer

user
rastactivist (author)2012-12-15

Thanks a lot Steve
i would like to try to connect it with my arduino uno
any clues ?

Select as Best AnswerUndo Best Answer

user

You've got to do something to get the 3v3 logic/supply to the GPS and the 5V logic of the Arduino sorted out. Tricky. You need to use 3v3 logic level translators really, like the 74HCT series to get from 3V3 to 5V and the 74HCseries to go from 5V to 3v3.

If your eyesight is VERY good, then the MC74VHC1GT125 is a lovely (LITTLE) part for a single logic line, because you can run it on 3v3 or 5V depending which way your signal is going.

Select as Best AnswerUndo Best Answer

user

Thanks again

your advice + this web site:
http://playground.arduino.cc/Tutorials/GPS

and it works !!!!

Select as Best AnswerUndo Best Answer