Introduction: 007 Trademark Logo
This is the 007 trademark logo commonly seen at the beginning of the 007 movies.
Step 1: Supplies
You will need a piece of paper and a pencil (or pen). You will also need scissors (optional).
Step 2: Circles and Lines
Draw a circle on the paper. Make sure it isn't too small. Draw a circle with a smaller radius than the circle you just drew. You have now made a ring. Now draw curved lines in the ring.
Step 3: The Man
Draw a silhouette of a stick figure look-alike with a hat inside of the ring.
Step 4: Gun and Numbers
Draw a silhouette of a gun in the man's hand. Next, draw 007 above the man in 3-D.
Step 5: Cut... and Done!
You can cut the picture out if you so desire. Once you have cut or left it the same, you are done
Comments
10 years ago on Introduction
Duh duh naaaah duh! Gotta love the music that comes with it!