1600X Current Amplifier

Introduction: 1600X Current Amplifier

About: I am robotics engineer and a teacher whose passion in life is breaking down the maths and academic jargon of programming and robotics into something that everyone can understand, primary school kids included.…

This is a simple device with just 3 components that amplifies currents 1600 times, It uses a neat trick of a transistor amplifying another transistor, otherwise known as the Darlington pair to amplify the MINISCULE current flowing between a persons finger and the ground sufficiently to light a 3mm LED

The transistors are 2N3904 NPN.

Components used:

•Arduino Uno

•400pts Breadboard

•2N3904 Transistor X 2

•LED

•Jumper Wire

PDF handout downloadable below:

p.s: too easy for ya?, well its a part of a free, fully documented (programs+schematics) online course designed to get young kids into electronics, so if you think it's any good pass it on?

Be the First to Share

    Recommendations

    • Jewelry Challenge

      Jewelry Challenge
    • Photography Challenge

      Photography Challenge
    • Anything Goes Contest 2021

      Anything Goes Contest 2021

    3 Comments

    0
    ibenkos
    ibenkos

    7 years ago

    Smart idea! Thanks for shearig :)

    0
    Robotix_au
    Robotix_au

    Reply 7 years ago on Introduction

    You are very Welcome, awesome profile page... you are one badass maker!