3D Printed IPhone Skateboard Mount for Recording Video
Intro: 3D Printed IPhone Skateboard Mount for Recording Video
I designed a mount for my iPhone to record video while riding on your skateboard or longboard. I modeled the prototype using the eta version of Rhino for Macintosh and it was printed with an Objet printer in the Fabrication lab at the University of Florida.The mount pivots 360 degrees horizontally. The phone fits very snugly into the case and is pushed down into a foam strip at the bottom of the case inside it. The latch secures the phone in the case and there is about 3 mm of plastic on the front and back and the banner around the phone is about 10mm of plastic. This is an ongoing project and I still have a few kinks to work out with the design. I hope to take this project to the next level, by reducing vibration and increasing overall strength of the material.
13 Comments
___ 11 years ago
firebolt9576 11 years ago
gmailman0998 11 years ago
kramt 11 years ago
projectsugru 12 years ago
You can send me your address by PM and I'll ship it straight to you :)
Keep up the great work.
thegreenassassin 12 years ago
Ian.TSSJ 12 years ago
Rgchin 12 years ago
William930 12 years ago
Turtlepwr 12 years ago
KennyJW 12 years ago
thegreenassassin 12 years ago
desertsniper 12 years ago