3D Modeled Controller for Basic Stamp Board of Education

Step 1 was to model the basic stamp board of education, I then modeled a basic controller in halves, in Solidworks. I printed these halves and spray painted the controller. I have included a video of the finished product in action.

Comments

[jclaudiu]

Ok i get it, i have a basic stamp 2 module and a board. Can i do this project for myself ? What components did you used ? :)

[JTatro2]

You sure can try. I have included my solidworks part files for the controller. The most difficult aspect of the project was mounting the servo motor and finding a suitable material that will allow you to mount the target. Behind the target is a magnet and a magnetic switch. The various jumper wires, buttons, and resistors came from the Basic Stamp 2 kit. Good luck.

[jclaudiu]

what`s this project about? i don`t get it :-/

[JTatro2]

The controller is part of a Mechatronics project. Basically, the controller houses the microcontroller. The Basic Stamp microcontroller is mounted to the bottom half. A Program allows me to control a servo motor with a BB gun target on the end.

This is a better video...

https://www.facebook.com/photo.php?v=616273175050326&set=vb.100000029478506&type=2&theater