3d Printed Monkey Fist Jig

By in Workshop3D Printing

2,645

10

3

Introduction: 3d Printed Monkey Fist Jig

By
About: I am a teenager who is studying Principles of Engineering at DTSMA high school and a future engineer.

This is for those Boy Scouts, the military men, or the average knot fanatic who no matter how hard they try, they just can't get a good monkey fist without a jig. Well, worry no more, folks, for the solution is here!
Please note that this is a design only due to the fact that I don't have a 3d printer, but I am saving and entering this in the 123d contest.
Please note also I am not responsible for anything that may happen with this or anything that might come from this

Be the First to Share

    Recommendations

    Mobile Folding Craft Station
    Mobile Folding Craft Station by Yvette M in Woodworking
    115 5.6K
    3D Printed Flexi Snake
    3D Printed Flexi Snake by Penolopy Bulnick in 3D Printing
    45 3.6K
    Glow in the Dark Molecules
    Glow in the Dark Molecules by mphatsosimbao in 3D Printing
    5 986
    A Pocket Sundial From a Broken Pocket Watch!
    A Pocket Sundial From a Broken Pocket Watch! by JGJMatt in Metalworking
    78 7.8K

    • Big and Small Contest

      Big and Small Contest

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    • Make It Bridge

      Make It Bridge

    3 Comments

    0
    ibwebb
    ibwebb

    9 years ago on Introduction

    Nice pic, but where is the instructable? No measurements? Bet this was nice though.

    0
    Halphinian
    Halphinian

    Reply 9 years ago on Introduction

    sorry about that; this is my first 123d design instructable and I will get the measurements as soon as possible

    0
    ibwebb
    ibwebb

    Reply 9 years ago on Introduction

    I look forward to it. I hope to build one someday and finding the measurements is as hard as finding a good instructable (which yours seemed very good).