555 Chip PCB Schematic (Charge Controller)

Introduction: 555 Chip PCB Schematic (Charge Controller)

Chip Schematics for a charge controller for a solar panel or windmill.

Be the First to Share

    Recommendations

    • Battery Powered Contest

      Battery Powered Contest
    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest

    10 Discussions

    0
    AkeY4
    AkeY4

    4 years ago

    helo please sameone can give me the shematics diagram of this ; very importante for my projet;

    thanks

    akeyveslain@gmail.com

    0
    skullhead690
    skullhead690

    8 years ago on Introduction

    but found that the design above wasnt good enough so had to re-design it.

    0
    peter6961
    peter6961

    Reply 6 years ago

    same design as Michael davis 555 charge controller :-), is the IRF540 on the left and 78xx regulator on the right? or is it the other way around? please get back to me as his cuircit with your pcb will be my first electronic project for me homemade 250w VAWT on a 12v system :-), also my email is hulkgq@gmail.com. thank you

    0
    Kiteman
    Kiteman

    8 years ago on Introduction

    Can we have some (a lot) more detail?

    What is this PCB for?

    How do you make it?

    What do you populate it with?

    0
    skullhead690
    skullhead690

    Reply 8 years ago on Introduction

    How do i make it? Do you mean the schematic or the actual pcb itself?

    0
    Kiteman
    Kiteman

    Reply 8 years ago on Introduction

    I mean... Any details at all. Just posting a diagram is not a lot of use without context at least.

    0
    skullhead690
    skullhead690

    Reply 8 years ago on Introduction

    well like i said below it is a charge controller for a windmill. the circuit is to be able to transition between a battery supply and a dummy load when the windmill has fully charged the battery supply. so as to not overcharge the battery.

    0
    skullhead690
    skullhead690

    8 years ago on Introduction

    Sorry guys, didnt post it for an actual guide. just needed to put it online so i could print it. But to answer your questions, its a charge controller for a windmill.