ARDUINO RC CAR

Introduction: ARDUINO RC CAR

This is how i made my arduino rc car.

Step 1: THE CARRIAGE

This is the first part of the rc car building project. In this video i assembly the carriage.

Step 2: THE FRONT AXLE

This is the part 2 of the arduino rc car building. Here i make the front axle.

Step 3: THE ENGINE AND REAR AXLE

This is the part 3 of building the diy arduino rc car. In this part i
mount the engine and the rear axle. You can download the printed parts and make your own rc car.

Step 4: THE POWER STEERING

This is the part 4 of the rc car building. I mount the power steering.

Step 5: ARDUINO UNO MOUNT

In this video i will mount the arduino uno board on rc car frame.

Be the First to Share

    Recommendations

    • Remote Control Contest

      Remote Control Contest
    • Eggs Challenge

      Eggs Challenge
    • Backyard Contest

      Backyard Contest

    Comments

    0
    KimberlyC94
    KimberlyC94

    Question 4 months ago on Introduction

    Hi, did you 3D print some of the parts? If so, where did you get the design?

    Thank you!