ATM Machine Using Arduino (Finger-print+RFID Card)
Intro: ATM Machine Using Arduino (Finger-print+RFID Card)
Hello friends ,I come back with new idea of ATM machine using Arduino .It can be helpful in rural areas where cashless services are not possible.It is a little idea .I hope you enjoyed it.
Let get started............
STEP 1: Components Required:
Arduino UNO.
GSM 900 (any GSM Module).
Finger-print scanner Module(GT511).
RFID EM-18.
Lcd 16*2.
12v Motor.
Buzzer.
12Volt 3Amp adater.
ULN 2003 and relay.
keypad.
Voltage regulator 7805.
Any piece of sheet for body(I use sunboard).
LED's.
STEP 2: Libraries Required:
EEPROM (inbuilt).
LCD library (inbuilt).
Finger print (GT511)
you can download here:
https://github.com/sparkfun/Fingerprint_Scanner-TTL
Key pad library:
you can download here
STEP 3: CODE:
You can download code from here:
STEP 4: Circuit Diagram
The circuit diagram shown in figure:
i add isis design for simulation
15 Comments
carlosgallabthor7 1 year ago
8miles 5 years ago
Ns2009 3 years ago
NSS92 5 years ago
sandeep jagdev 5 years ago
NSS92 5 years ago
sandeep jagdev 5 years ago
NSS92 5 years ago
sandeep jagdev 5 years ago
NSS92 5 years ago
NSS92 5 years ago
NSS92 5 years ago
www.tebarek123456789bargicho 6 years ago
HOW I CAN DOWNLOAD ALL OF THESE PROJECT INCLUDING THE DESIGN AND CODE
Hackster2 6 years ago
where did u attached gsm module and if i don't wanna use rfid
sandeep jagdev 6 years ago
i use only transmitter pin for sending message with gsm and i connect rfid to receive pin