Adjustable Tablet Stand With DVD Case ( Ipad / Touchpad )

By in CircuitsComputers

9,887

36

8

Introduction: Adjustable Tablet Stand With DVD Case ( Ipad / Touchpad )

Step 1:

Be the First to Share

    Recommendations

    Plug It - Open Source Smart Plug
    Plug It - Open Source Smart Plug by Thomas Huyghebaert in Gadgets
    9 1.7K
    Giant Cardboard Knife Switch
    Giant Cardboard Knife Switch by BrownDogGadgets in Electronics
    1 224
    Build a Super-sized Expandable Seven Segment Display
    Build a Super-sized Expandable Seven Segment Display by DIY Machines in Electronics
    5 475
    Color-Changing Prom Dress With Magic Wand
    Color-Changing Prom Dress With Magic Wand by kellechu in Wearables
    14 5.9K

    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge

    • Build a Tool Contest

      Build a Tool Contest

    • Pets Challenge

      Pets Challenge

    8 Comments

    0
    alexspano88
    alexspano88

    7 years ago

    Added a couple things
    Adjustable slipknot for horizontal viewing
    Hooks on back for vertical viewing
    Credit card stabilizer on front
    Thanks!

    temp_2103552304.jpgtemp_2036412201.jpgtemp_1872752281.jpg
    0
    FrozenIce
    FrozenIce

    9 years ago on Introduction

    Awesome!! I cant believe no one (especially me) had never thought of this before!! Genius!! May i ask, what was your initial motivation/inspiration?

    0
    masterxdk
    masterxdk

    10 years ago on Introduction

    I have just made it without glue and its adjustable :)

    The "hooks" to grab the manual or whatever inside the DVD case, i have bend out and used a string to put the two sides together. This string can be tied so the two sides can be as far from each other as you like... :)

    0
    chaitanyak
    chaitanyak

    10 years ago on Introduction

    brilliant idea to use a dvd case like that!
    i must make this too :)

    0
    hardwarehank
    hardwarehank

    10 years ago on Introduction

    I'll probably be making this for my flight tomorrow! Thanks!

    0
    hardwarehank
    hardwarehank

    Reply 10 years ago on Introduction

    Made one from a slim DVD case. I happened to have about 50 of them already. I changed the recipe a little - instead of hooks, I used short pieces of solid 12-gauge insulated wire. I dotted the outer ends with hot glue to cover the copper and prevent pad-scratching. I then inserted the other ends of the wire into the holes that were already in the slim case (after cutting the transparent membrane off). I bent them up on the inside and hot glued them to the inside of the case. Then, I hot glued in a wire like you did. Works perfectly - thanks a ton!