Step 1: Trim Gasket to Width (I Went With 3/4 Inch
Step 2: Mark and Trim Ends to Dress It Up a Little
Step 3: Punch Holes- I Spaced Them About 1/2 Inch Apart , That Gave Me 11 Holes for 10 Pellets and a Lanyard
Step 4: After Making a Pellet Seater I Attached All Together With a Lanyard
Step 5: The Seater Is a 1/2 Inch Dowel With a Bbq Skewer for the Center Pin to Seat the Pellet, Cut It Long at First So You Can Trim It to Get the Depth on the Pellet You're Happy With
2 Comments
3 years ago
Nice job on your first Instructable :)
Reply 3 years ago
Thanks