Altoids Tiny Tin IPod Shuffle Case

by TheMoonMaster

6.1K33

Intro: Altoids Tiny Tin IPod Shuffle Case

I've seen a lot of altoids iPod cases on this site but none for the shuffle which is less common but lots of people still have it. So heres my plan for a shuffle case using an altoids tiny tin which are sort of hard to find but are useful

STEP 1: Cut the Tin

Open the tin and make a square shaped hole on the side of the tin as shown. You can cut it with a dremel but I used a pair of wire cutters so it came out kind of sloppy.

STEP 2: Your'e Done!

Now just put your shuffle in and thread the headphone cord out of the hole as shown. Now close it up and continue on your mery way!

3 Comments

nillin 13 years ago

Do you think Altoids are available in the Philippines?

Aznhick 15 years ago

I haven't tried this, but I would think that the edge of this could damage your wires. If the case shifted in your pocket to make the wire pull against it I think it could cut the wire. I think cutting flaps into the edge and bending them backwards would round out the hole and also make the opening in the case smoother.

Nicrostar 15 years ago

Nice, I would add some padding inside of the case. Just in case you drop it.