Introduction: An Aesthetic Phone Case From Electronic Components

About: Second year engineering student studying at the Beautiful Okanagan campus of The University of British Columbia. I like to tinker with electronics and meddeling with 3D printing. I also have a penchant for rea…
So this began as my last attempt to make a case for my phone. My first attempt was trying to make a metal mold however the mold broke. ( click here if you want to try that instead). This case has it's problems: the case is vary fragile, It's also quite sharp, it leaves a small glue residue each time you put it onto the phone, and it covers the camera and the speaker. However I think it turned out ok in terms of looks. If you wish to make your own post a comment and I'll do a full step by step ible, or just wing it. Pretty much anything can be added to this case as it is just a modge-podge of stuff that represents who I am. I chose electronic components because that is what the phone is made off and because they could be soldered on. I would not suggest solder if you were to make this as it is too brittle and sharp.  I apologize for the less than spectacular pictures I'm still working on getting a camera. Thanks for reading hope it's not to bad.