Android USB Design

Introduction: Android USB Design

Using an old small USB device I had sitting at home I have designed an Android case for it. First I looked up some designs people had made, I got inspired by these and I brainstormed these ideas till I got to one idea using a decision matrix. Next I sketched out my design keeping in mind some constrains I would have (size, if the cap would fit, portability, etc.). Then I transferred my sketches onto Autodesk Inventor.Lastly I converted the parts to an STL file and sent it in to print. This project has took me close to three weeks to complete and print out. I hope you like it.

I have used all the steps of the design process to complete this project.

P.S. if you are going to print it out, the jump drive I have used was the HP 165w
http://www.amazon.com/v165-USB-Flash-Drive-P-FD4GBHP165-AZ/dp/B0051G5RRY

Make It Real Challenge

Participated in the
Make It Real Challenge

Be the First to Share

    Recommendations

    • Remote Control Contest

      Remote Control Contest
    • Meatless Challenge

      Meatless Challenge
    • Fabric Challenge

      Fabric Challenge

    Comments