Arduino Light System

Introduction: Arduino Light System

To make this arduino light system you will need the folowing.

7 jumpers

6 LED's

1 arduino

1 breadboard

6 220k resistors(red,red,brown)

1 10k ohm resistor(brown,black,orange)

Step 1: Angle 1

Each step from now on will just be of photos on how to setup your Arduino Light System.

Step 2: Angle 2

Step 3: Angle 3

Step 4: Angle 4

Step 5: Angle 5

Step 6: Finished Project

Step 7: First Par of the Code.

Step 8: Second Part of Code.

First Time Author Contest 2016

Participated in the
First Time Author Contest 2016

Sensors Contest 2016

Participated in the
Sensors Contest 2016

Be the First to Share

    Recommendations

    • Hand Tools Only Challenge

      Hand Tools Only Challenge
    • Modify It Speed Challenge

      Modify It Speed Challenge
    • Remix Contest

      Remix Contest

    2 Discussions

    0
    jacobtschiele01
    jacobtschiele01

    4 years ago

    I'm sorry but there should be 9 jumpers and a photoresistor

    0
    DIY Hacks and How Tos
    DIY Hacks and How Tos

    Reply 4 years ago

    If you want to edit the Instructable, there is an EDIT button on the right side of the page that will let you go back into the editor to make any changes that you need to.