Arduino Motion Detector
Intro: Arduino Motion Detector
The Screen Display To You "Motion Detector" Then Displaying My Name Then Displaying "Processing data"
For Eight Seconds To Give You Time To Go a Way Hope You Like This Project : )
STEP 1: Parts List
in this project you will need :
1 : Arduino UNO
2 : P.I.R Sensor
3 : 16 x 2 LCD Screen
4 : Bread Board
5 : Jumper Wires
6 : Small Jumper Wires
7 : Buzzer
8 : 10K Resistor
9 : ِAnd Of course a USB Cable
STEP 2: The Circuit Connections
The LCD Screen :
Pin 1 : To Ground
Pin 2 : To +5
Pin 3 : To The Middle Pin Of The Variable Resistor
Pin 4 : To Arduino Digital Pin 13
Pin 5 : To Ground
Pin 6 : To Arduino Digital Pin 12
Pin 7 : X
Pin 8 : X
Pin 9 : X
Pin 10 : X
Pin 11 : To Arduino Digital Pin 11 ~
Pin 12 : To Arduino Digital Pin 10 ~
Pin 13 : To Arduino Digital Pin 9 ~
Pin 14 : To Arduino Digital Pin 8
Pin 15 : To Arduino Digital Pin 6 ~
Pin 16 : Ground
The Variable Resistor :
Most Right Pin To +5
Most Left Pin To Ground
The P.I.R Sensor :
GND to Ground
VCC to +5
OUT to Arduino Digital Pin 7
The Buzzer :
Negative to Ground
Positive to Arduino Digital Pin 6 ~
STEP 3: The Code
Download The code file and run it ! : )
5 Comments
DIY Hacks and How Tos 8 years ago
Cool motion sensor project. Thanks for sharing.
Baraa Halabi 8 years ago
Your Welcome : )
yaser ha 8 years ago
كويز يا خوية
nishant arora 8 years ago
Baraa Halabi 8 years ago
The P.I.R sensor is a thermoelectric element reveals the existence of movement through the sensor changes in the levels of infrared rays emitted by the objects surrounding it and turning it into electric signal
and you can adjust the sensitivity and delay time
in my case the range was from (0.5 - 4) meters