Introduction: Arduino Pong
My version of pong built using an arduino, a 8x8 led matrix, a couple of 595 shift registers, potentiometers for input control and a Lcd to keep score.
Current version is hardware complete, next step is to solder it onto a prototype board and then fit it into a case.
Arduino sketch can be found on github .
3 Comments
8 years ago on Introduction
well that not very easy to read
9 years ago on Introduction
um bom projeto
10 years ago on Introduction
do you have a circuit that is a bit more readable
i mean wires that go cris cross make them hard to read