Arduino Wireless CAR
Intro: Arduino Wireless CAR
Hi,
This Project is made with 2 arduinos boards (UNO for CAR) and NANO for transmitter.
I am also using H-Bridge chip to control motors.
The transceiver is NRFL2401 which is SPI controlled by Arduino.
The car chassis is from Ebay, it uses 4 motors.
The motors are connected 2 motors at same side together, so basically I am controlling only 2 motors (instead of 4)
See the movie below
Uploaded my code here:
Code of Receiver and Transmitter
Thanks,
Roee
6 Comments
RoeeB 7 years ago
sure you have it on site goto this link
http://www.electronicsfreak.net/arduino-remote-con...
SevaV 7 years ago
hi. the site is offline, can you send me de code to seva@motocilcistas.cl
amberrayh 8 years ago
Thanks for sharing. Do you have the code that you used for the arduinos?
RoeeB 8 years ago
I will upload it to my site
Thanks,
Roee
amberrayh 8 years ago
Thank you!
RoeeB 8 years ago
Ok,
I have uploaded my code.
Pay attention in the same page you have the code for Receiver and Code for Transmitter, take the correct part and compile it
http://www.electronics-freak.com/arduino-remote-controlled-car-code/
Enjoy,
Roee