Introduction: Assembly Workbench
Here is another Shanty-2-Chic design. This bench is about 1/2" shorter than the miter bench and a full 8' in length. I order some Kreg tools to make this design more applicable to what I'm doing.
I will be adding rails for the Kreg clamps and a woodworkers bench vise.
This step I made the legs. Photo shows the legs screwed together.
Step 2: Legs
Next I made all of the cuts for the frames.
Step 3: Top and Bottom Frames
I assembled the top and bottom frames as shown in the photos.
Step 4: Attached Legs
Next I attached the legs to the bottom frame using wood screws.
Step 5: Shelf and Top Frame
Next I added the plywood to the bottom frame.
I flipped the unit on its top to add the top frame and casters.
Step 6: Finished
Flipped back over and now done.
6 years ago
Very nice design :)
Reply 6 years ago