Autonomous Vehicles

5,907

9

3

Introduction: Autonomous Vehicles

About: A boy that loves aviation, music and electronics

Hi friends of instructables. I am here again with a very interesting project. If you have children, they will be fascinated. Imagine that you set up a toy car with an engine that only goes forward. certainly when it finds a wall, hit. Well that prevent it hit? to stop before hitting him?
Ok. Now you are wondering what is my project, right?
Based on an infra-red sensor to analogue, I build this autonomous car.
The circuit has few components and is easy to mount and only a little difficult to adjust the angle of the sensor.

Step 1: The Parts

To mount it you need the following parts:

-1 Relay to 9V with two contacts (one normally open and one normally closed)
-1 U.B white LED
-1 IR LED (TIL 38)
-1 photo-transistor (TIL 32)
-2 1K resistor
-1 9v C.C engine
-1 9V battery connector
-1 chassis of an old toy car (preferably one that already has an engine, lock the pictures)

Step 2: Mounting...

Make the initial assembly on a test plate as the angle of the sensors (IR LED set and photo-transistor) determine the sensitivity, and a little error in the angle, the circuit does not work.
After all right, made his final card and mount your toy = D. follow the scheme .

Step 3: Finish

after having mounted plate, housing the circuit in the car and have fun.
Ready? Well this all done, enjoy your child and be happy =D
until the next. Bye!

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    3 Discussions

    0
    intiguy
    intiguy

    9 years ago on Step 3

    and pretty easy!
    thanks!

    0
    Nemweb
    Nemweb

    Reply 9 years ago on Step 3

    No problems guy! I'm happy by your comment! Thanks!