BASIC KNEX SWORD

Introduction: BASIC KNEX SWORD

About: Finally back to life. Probably won't be on much on 'ibles, but I'll be fairly active on Discord (PartMan#7123) - feel free to chat on the Flux! Oh, and I would like to apologize for being so cringy years ago.

Please be kind in the comments, this is my first instructable.

Step 1: Parts List

Here is the parts list.

RODS
Grey/Clear/Black:1
Yellow:1
Blue:4
Any 8 pieces for decoration

CONNECTORS
Blue 3D:2

Step 2: Main Body

Attach the pieces as shown.

Step 3: Decor and Finishing

You can attach any eight pieces

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpt & Carve Challenge

      Sculpt & Carve Challenge

    10 Comments

    0
    PartMan7
    PartMan7

    Reply 7 years ago on Introduction

    I only have 1269 pieces and most of those are in my bow..................

    0
    sandroknexmaster
    sandroknexmaster

    Reply 7 years ago on Introduction

    Ok. I don't mean it's bad, I just mean it doesn't look like a sword...

    0
    PartMan7
    PartMan7

    Reply 7 years ago on Introduction

    Try sword fighting with two of these, I doubt anyone has enough pieces to make two large swords.

    0
    sandroknexmaster
    sandroknexmaster

    Reply 7 years ago on Introduction

    1) A lot of people can build 2 large knex swords.
    2) I'm sure you can sword fight with these, but it doesn't look like a sword, with all that rods sticking out :p

    0
    PartMan7
    PartMan7

    Reply 7 years ago on Introduction

    The link is:https://www.instructables.com/id/Knex-Broadsword/

    0
    hunter999
    hunter999

    Reply 7 years ago on Introduction

    looks like a fencing sword kinda..

    0
    PartMan7
    PartMan7

    Reply 7 years ago on Introduction

    And also, it used 1253 pieces. I didn't have enough pieces to make a big sword.