Introduction: BB Holder

About: Leave a comment.
This will help reloading much faster and you will only need a few house hold items.

Step 1: Items

You don't need very much:

- Film case

- Normal pen

- Tape ( i used duct tape)

-Scissors/ Knife (there is no picture for the knife)

-BB's

Step 2: Creating the Case

Cut a hole in the lid of the film case. (see picture 1 to see were to cut)

Now take apart the pen. (all you need is the cap)

Cut the pen cap at the very top and the long piece that hands off.

Place the pen cap in the hole of the film cap and then tape it so it will hold, put the film cap bach on.

It should now look like picture 3

Step 3: Load Your Ammo

Now take off the cap and pour in some BB's

To load your clip just pour the BB's out the pen barrel and into the clip.

( you may need to shake it for the BB's to come out)

-Leave some comments