Barrel Head Sign Made With a Supersized Shapeoko CNC

Introduction: Barrel Head Sign Made With a Supersized Shapeoko CNC

About: My Name is Brandon Fischer. I am a Theatrical Rigger and Carpenter. I like to build, make, and void warranties. Please visit my Etsy shop. http://www.etsy.com/shop/ImprobableConstruct

This is a sign I made as a gift on my supersized Shapeoko.
It is cut into the inner side of a white oak wine barrel head.
The coloring is from years of contact with red wine.
I used a 1/8" two flute end mill for the pocket cut around the tree with a 1/16" 4 flute end mill for the finishing pass and a 1/2" V-bit for all of the lettering.

The barrel head is not flat or level so it was a bit of a challenge to find a good Zero for the Z-Axis.
There is about 1/8" between the thinnest board and the thickest one.
In the end I used the thinnest board. (the one just right of center) for my zero.
The board with the "EST." carved into it is one of the thicker boards but the wine really soaked into it so it looks shallow.
I plan to coat it with a wax based UV protective coating.

Digital Fabrication Contest

Participated in the
Digital Fabrication Contest

Instructables Design Competition

Participated in the
Instructables Design Competition

Be the First to Share

    Recommendations

    • Electronics Contest

      Electronics Contest
    • Stone Concrete Cement Contest (Share a project using stone, concrete and/or cement. May 23.)

      Stone Concrete Cement Contest (Share a project using stone, concrete and/or cement. May 23.)
    • Digital Fabrication Student Design Challenge (May 23.)

      Digital Fabrication Student Design Challenge (May 23.)

    Comments